Pipe Spray Painting Machine is mounted on wheels, and paint is aspirated in a hose that sucks paint from any container, including drums. The unit shall have inbuilt agitator that keep the paint uniformly mixed during the spraying. The unit shall consist of inbuilt strainer. Usually very small quantities of thinning are required before spray. In case of High Build Epoxy coating (two pack). 30:1 pump ratio and 0.020-0.023” tip size will provide a good spray pattern. Ideally fluid hoses should not be less than 3/8” ID and not longer than 50 ft to obtain optimum results. In case of gun choking, de-choking steps shall be followed immediately.
What Are Spray Painting and Powder Coating?
Spray Steel Pipe Painting Production Line is the process of applying liquid paint using pressure. This can be done in one of three ways:
Conventional high-pressure spraying
High-volume low-pressure (HVLP) spraying
Conventional High-Pressure Spray Painting
This method uses an air compressor and an air gun. When the gun's trigger is pressed, the paint mixes with the compressed air stream and a fine spray is released from the nozzle.
The air gun is usually held about 6 to 10 inches from the object being painted and moved back and forth over the surface to ensure an even and continuous coat.
Airless Spraying Systems
These Steel Pipe Spraying Coating Machine systems use a high-pressure pump, which can range in pressure from just 300 to 7,500 pounds per square inch, depending on the application.
Laser marking works by using a focused beam of light to mark the surface of a material. When the beam interacts with the material’s surface, it alters the material’s properties and appearance. This concentrated beam targets only a specified area, allowing the laser Automatic Marking Machine to create precise, high quality, high-contrast marks that are easy to read or scan on virtually any surface. This feature makes laser marking ideal for applications where accuracy and permanency are critical to success.