تسجيل الدخول لسرعة الوصول إلى أفضل الصفقات. انقر هنا إذا لم يكن لديك حساب.

Hydraulic guillotine shears V.S Swing beam shears Professional

منذ 4 أشهر Multimedia Saïda   63 الآراء

-- دج

  • img
موقعك: Saïda
السعر: -- دج

Nowadays, the famous shearing machine manufacturers all over the world are mainly producing hydraulic guillotine shearing machine, and the price is slightly higher.Compared with the hydraulic swing beam shearing machine, the hydraulic guillotine shearing machine has the advantages of high shearing precision, adjustable shear angle and long service life of the cutting edge.

The Cable Wire Recycling Machine is a waste wire and cable processing and recycling equipment. It has the advantages of small area, low energy consumption, high copper-plastic separation rate, and simple operation. It is favored by market bosses in the metal recycling industry. Mainly recycle and process automobile circuit wires, communication cables, miscellaneous wires, etc., with one feeding and a single machine. The equipment adopts a closed production mode and has a good dust removal effect. The appearance of the Cable Wire Recycling Machine has solved the environmental pollution caused by the incineration of copper. It not only improves the quality of recycled copper, but also has the advantage of recycling plastic. Some rubber shoe factories will use the sorted rubber for the soles of rubber shoes. In this way, it is full of treasures. Cable Wire Recycling Machine equipment is not only a representative of green in the machinery industry, but also reflects the customer's pursuit of interests. The old-fashioned recycling process of waste electric cables-produced under the pressure of major environmental pollution caused by incineration. The Cable Wire Recycling Machine equipment recycles waste wires and cables cleanly and environmentally. It can treat waste wires without causing any environmental pollution. The plastic and metal copper in the cable are fully recovered, mainly by mechanical physical crushing, and then the crushed metal-plastic mixture is separated from the crushed metal and plastic by a specific gravity separator. This is a typical new type of machinery and equipment that turns waste into treasure, conforms to the development of environmental protection and energy conservation, S0 guidance should be strongly advocated.

Types of Press Brakes

Modern press brakes are much safer and don’t require nearly as much effort as earlier models. In fact, modern brakes have increased the speed, quality, and efficiency of bending metals. When it comes these modern brakes, there are three common types: manual, hydraulic, and CNC.

Manual Press Brakes: also known as sheet metal brakes, these are the most common type of brakes. Manual brake presses require you to manually adjust the bending dimensions and angle at each cut, and are best used for the mass production of set bending sizes and angles. Hydraulic Press Brakes these brake presses utilize two hydraulic cylinders, allowing more control and consistent strokes.